NL- Sanguinololu v1.3 electronics for sale and heated printbed's MK1

Because I wanted to have a sanguinololu for myself I ordered a batch of pcb's in China, made my own board and now I am selling the rest. The boards are completely soldered and the atmega is already programmed with the kliment/sprinter software. I prefere to sell completely soldered kit's because many people tend to have problems soldering the ft232.



A completely soldered board with the stepstick drivers will cost you €110.

uninsured shipping:
Europe: €7,-
World: €11,-

insured shipping
Europe: €10,-
World: €17,-

If you have specific whishes for firware or anything don't hesitate to send me an email!

Edited 1 time(s). Last edit at 11/08/2011 08:32AM by Bas.

now also on ebay:

[cgi.ebay.nl]

BTW: If you want a DIY kit that's also possible. It will save you €25 but I will still presolder the ft232 for you and programm the atmega. Just send me an email

I also sell heated printbeds right now:

[www.ebay.nl]



€27

Edited 1 time(s). Last edit at 11/08/2011 08:31AM by Bas.

hi there i brought a board like this and the mosfet for the heat bead fried itself the firsttime i used it and reason this could have happened

Hi . pelase send me for firmware for sanginololu rev 1.3a.Thank you.