we print the hydrogen generator of the car use the 3d printer

Technical Specifications:

Length: 7.2"
Width: 1.9"
Height: 7.35"
Power Requirements: 12v-14v/can operate up to 8.4 Amps continuously (PWM needed in all cases, we made test also without but in this case will as any other cell and this cell will termal run away)
When in series can be used 24 v,110 v and 220 v
Plates: 7
Each plate working area : 3.9" x 3.9" each side (Excluding the end positive and negative plate, just one side produce HHO )
Gaskets: None instead special membrane with holes used
Cell Surface Area: 186"
Performance: 0.53 LPM at 8.4 Amps Arrangement: +NNNNN-
Fittings: straight barbs for 10 mm hose
Manufacturer: Asteros Ltd

If you want to get this hydrogen generator or want more information, you can come go3d store, if you want receive STL file, please contact me.(email:[email protected])