I need to sell my printer that I built based on the Lulzbot TAZ. I built it in a smaller version (200X200 bed instead of 300X300) to be more compact. The printer is up and running but it does need some work to make it print good parts consistently. $650 plus shipping (or local pickup in SF Bay Area).
I want to be straight forward so there is no misunderstanding when you get the printer so I have listed a couple of the upgrades/projects that I had planned and didn't have time to finish.
Please let me know if you want more information about the printer or if you have any questions.
Upgrades that I was planning to do but didn't get around to:
Print and install electronics case
Print and install mounting brackets for power supply
SmartLCD display requires power from USB (should be able to run off main power supply, maybe a new diode)
Replace Acrylic y-table with aluminum (aluminum plate included in extras)
Stiffer X-Ends, new version of bearing holders
Print Area: 200X200X180mm (approx)
Electronics: Ramps
Bed: Heated
Filament Type: 3mm (PLA, ABS)
Extruder: Lulzbot BudaSnozzle
SmartController LCD w/ SD card
Extras:
- Kapton Tape (almost full roll)
- Filament (ABS and PLA)
- Pulolu Motor Drivers x2
- Hall effect endstop sensors
- Extra belts
- Extra misc wiring
- Extra misc hardware
