PrintrBoard REV D
We are into manufacturing of Electronics for 3D Printers such as PrintrBoard Electronics. We have them in stock.
For More Information about Printrboard Refer : [
makemendel.com]
We provide the PrintrBoard with best quality at a competitive price.
Quick Overview
Fully Assembled, Tested Printrboard Electronics REV D loaded with the Marlin Firmware and LUFA CDC Boot Loader
Printrboard set comes with all the items shown in picture
Special Price : $ 119.00 USD
• Offers Improved production grade by adding heatbed and SD card support , Allegro stepper drivers, Also elimination of the FTDI UART chip
• Printrboard is by far the fastest and most reliable Electronics.
• Printrboard works great with any RepRap: Prusa, Mendel, Printbot, Rapidbot,Orca etc.
Features :
• Atmel AT90USB1286 Microcontroller
• Four integrated Allegro A4982 Stepper
• Four 5V Endstop Connectors Supplied
• OnBoard SD Card Slot
• 2 N-MOSFETs for Extruder and Heatbed control
• 1 N-MOSFET for low power Fan or motor
• Revision D
• Green Power LED
• 4 layer, 2oz Cu PCB with ENIG Finish -- Excellent current handling & thermal dissipation
Softwares :
• Aurdino For Printrboard- For Working Printrboard Board Configuration
• Marlin Firmware - Lincomatic Marlin for Printrboard
•CDC BootLoader.zip - CDC BootLoader For Printrboard
This Printrboard Electronics Set Includes :
• LUFA CDC Bootloader* and Marlin RC2 firmware Pre-Installed
• 3 Pieces of 3 Pin Molex with Mechanical switch Pre Soldered.
• 2 Pieces of 2 Pin High Temperature Molex (for Thermistor).
• 1 Piece of 2 Pin Molex (for Fan).
• 2 Pieces of 4 Pin High Temperature Molex (for Heaters).
• 1 Piece of Micro USB cable.
• Resistor
All Molex are 600 mm Long
For more information visit our site :
http://makemendel.com/electronics-parts/printrboard