Welcome! Log In Create A New Profile

Advanced

V-Plotter with RAMPS 1.4

Posted by mnom 
V-Plotter with RAMPS 1.4
April 16, 2017 09:17AM
Hello!
I want to make Hanging plotter (v-plotter) with Arduino Mega, RAMPS 1.4 and two stepper motors. I'll think about pen lifting later.

There is no problems with the basic hardware setup.

The problem is software.

I've tried Marlin + Repetier, but it didn't work, I couldn't even make single motor run.

Ok, so there are some guides.

Polargraph software release: https://github.com/euphy/polargraphcontroller/releases/tag/2016-03-29-10-23

Using the Polargraph software with RAMPS motorshield - tweaking Arduino firmware.
https://github.com/euphy/polargraph/wiki/Using-the-Polargraph-software-with-RAMPS-motorshield

Tweaking polargraphcontroller to be able to run it on Linux and connect to MEGA +RAMPS https://github.com/euphy/polargraphcontroller/issues/14

The hardware is fully working - tested with ramps14test, motors spin, it's ok.
The problem is that even having polargraphcontroller connected to the board, sending and receiving all the needed commands, the motors themselves do not move. Assembly is tested and working. ramps14test rotates motors around as it should.

Where do I have something broken?

Edited 1 time(s). Last edit at 04/16/2017 11:40PM by mnom.
Re: V-Plotter with RAMPS 1.4
April 17, 2017 04:39AM
The test firmware does not look at endstops

The real reprap firmware will not move if endstops are triggered

Send the controller a M119 command

Any that report triggered, you cant move in that direction.

Edited 1 time(s). Last edit at 04/17/2017 04:41AM by Dust.
Sorry, only registered users may post in this forum.

Click here to login