Welcome! Log In Create A New Profile

Advanced

End of spool

Posted by chaosbc 
End of spool
January 16, 2017 06:28AM
Hi there
I believe it is really a shame that one cannot print the whole content of a filament spool.
Money wasting+no very eco friendly
I tried already the trick that consists in removing the spool to "release the filament pressure" but in the end ....it does not work for me...extruder stills has hard time pulling the filament
So I did an experiment (Be very carefull if you consider trying this....be safe....I will not be responsible for any damage.)
I rolled the end of the spool around my old metal waste basket then heated it with a heat gun.
Results were not what I expected but it was not THAT bad :
filament took more or less the shape of the basket but it looked more like pastas that really perfectly winded filament if you see what I mean.
Still I tried printing and it worked ...well...for few minutes and after this my extruder started to struggle to much to feed the hotend so this is not really a success.
Anyway....I still believe there is something that can be done....maybe heating slightly the filament meanwhile winding it to a more "serious" spool
Sorry if this is a old new idea but if you experienced somthing similar, I would be interrested in the details....

Edited 2 time(s). Last edit at 01/16/2017 06:30AM by chaosbc.
Sorry, only registered users may post in this forum.

Click here to login