Welcome! Log In Create A New Profile

Advanced

Select a face with FreeCAD

Posted by jalonsoro 
Select a face with FreeCAD
May 27, 2015 06:13PM
I have installed several versions of FreeCAD and with none of them I can select a face or line of any figure with the mouse. I tried with all the navigation styles. All other parts of the program seems to run properly. My mouse is an wireless Logitech. Does somebody know where is the problem?
Re: Select a face with FreeCAD
May 27, 2015 07:41PM
Hi,

You're probably better off asking this question in the FreeCAD forum rather than here. When you do ask there, give some details and screenshots showing exactly what you're trying to do.

But, FWIW, I've been using FreeCAD on Windows 7 & Linux machines, and can select lines and faces. I suspect your problem is that you're not switching FreeCAD to the right "Workbench". Understanding these workbenches is necessary to use FreeCAD. There are some good step-by-step tutorials on the FreeCAD site.

Frank
Re: Select a face with FreeCAD
May 29, 2015 02:06AM
I have the same on my computer but not my missus laptop. I put it down to graphics card or some hardware issue then software my computers got basic hardware to the specification of the laptop


Check my rubbish blog for my prusa i3

up and running
[3dimetech.blogspot.co.uk]
Sorry, only registered users may post in this forum.

Click here to login