so starting to build up stuff ready for when i get all my parts through and not sure which software i will be needing.
this is my list of parts
1 x soldered and assembled RAMPS 1.4 shield
1 x SD Ramps for Ramps 1.4
1 x Mega 2560
5 x soldered A4988 stepper driver
1 x Reprap RAMPS1.4 12864 LCD display controlle with adapter Mendel,Prusa 3D Printer
1 x heatbed MK2a(214mmx 214mm) with resistor and LED soldered
6x Mechanical Endstops V1.2
1 x cooler fan
1 xUSB cable
5×42BYGH47-401A STEPPER MOTOR
2 x T2-20 tooth Aluminum pulley,3m GT2 black timing belt
I'm running at the moment a duel boot windows 7 and mac mavericks so wanting to know if i can use mac to run this if so which software do i need or if not for mac but for windows either or i don't mind. would need 3d software as well have used other before but on a trial basis which has now ended so any free soft are recommendations would be good and then the software to run the printer.
thanks in advance