Looking for print cooling solution for E3D V6 October 26, 2016 01:47PM |
Registered: 10 years ago Posts: 153 |
Re: Looking for print cooling solution for E3D V6 October 27, 2016 01:36PM |
Registered: 11 years ago Posts: 1,049 |
Re: Looking for print cooling solution for E3D V6 October 27, 2016 05:54PM |
Registered: 10 years ago Posts: 153 |
Quote
cozmicray
Compressed air, when it expands, cools down greatly.
Just open the valve on a scuba tank and watch it frost up.
A fine nozzle jeting compressed air will expand and cool close to print surface.
Could be very small next to extruder.
Even very low pressure drop cools a lot.
Putting a Peltier cooler on fan inlet can frost your polymer / plastic
Re: Looking for print cooling solution for E3D V6 October 29, 2016 02:22PM |
Registered: 11 years ago Posts: 1,049 |
Re: Looking for print cooling solution for E3D V6 October 29, 2017 04:34PM |
Registered: 7 years ago Posts: 62 |