Sorry if this has been asked before but I think I made a big mistake when putting together my Wades Extruder with a J-Head MK IV-B hot end.
I assumed I could use 1.75mm filament but it keeps clogging. Now I am wondering if my liner is not supposed to take 1.75 mm filament.
The 1.75mm filament is not snug in the liner and now I am thinking that's because the liner is only for 3mm filament. It's hard to measure but the inside diameter is more than 2 mm.
Can someone confirm that the inner diameter of the liner has to match the filament? Or can i use 3mm and 1.75 mm filament on the same hot end?
Derek
