The best Extruder

which is the fastest and most consistent extruder out there? what do you guys think.

I don't think that someone has bought them all to test Main issue is that most don't give all the specs but some weird spec like mm/min or ipm without telling what the filament width is, others do give gram/min or gram/hour data but then again most don't give width fluctuation information.

IMHO Only filastruder has the most active community and a lot of information and most complete information.

As far as a Filastruder:

- [ABS: +/-0.02mm](http://www.soliforum.com/topic/7430/abs-mg94-and-gp35-review-and-comparison/) in some cases users [report +/-0.01mm](http://www.soliforum.com/search/607487942/)
- [PLA: +/-0.03mm](http://www.soliforum.com/topic/4108/my-filastruder-and-results-so-far-abs-and-pla/)
- [Nylon: +/-0.02mm](http://www.soliforum.com/topic/8237/nylon-taulamn-618-regrind/)
- [Polycarbonate: +/-0.04mm](http://www.soliforum.com/topic/9090/pc-polycarbonate-encom-pc-2012/)
- [PET - recycled T-glase: +/-0.05mm](http://www.soliforum.com/topic/8876/pet-tglase-regrind/)
- [Acrylic: +/-0.05mm](http://www.soliforum.com/topic/8499/acrylic/)


Output rates vary from 6-12 hours/kg, depending on filament diameter and material.

Hello !

I really wish to buy one, but it seems like many of the have problems, like air bubbles in the filament.

Im following the ProtoCycler, and of course they say their filament is perfect but Im searchin some other who have tried..

thanks!