Bed PID in config.txt

I don't see the Bed PID defined in the config.txt

Can I create these entries for the bed T control module ?

temperature_control.bed.p_factor 198.9 # P ( proportional ) factor
temperature_control.bed.i_factor 17.719 # I ( integral ) factor
temperature_control.bed.d_factor 558 # D ( derivative ) factor


PS: I don't want to use the command M504 to create the override config.

Edited 1 time(s). Last edit at 03/14/2018 04:02AM by MKSA.

---

"A comical prototype doesn't mean a dumb idea is possible" (Thunderf00t)

That's how you do it. Make sure there are no statements turning on bang-bang.

Edited 1 time(s). Last edit at 03/14/2018 09:26AM by the_digital_dentist.

---

Ultra MegaMax Dominator 3D printer: [drmrehorst.blogspot.com]

Thanks.

Just a bit surprised they didn't put it but defined a second hot end (commented out) plus some confusion regarding the autotune PID command where E0 is the hot end and E1 the bed.
I guess it is due to history as initially there was just one hot end and a bed.

Just took the hint and listen to this great song
"I was five and he was six
We rode on horses made of sticks
...Bang Bang" Nancy Sinatra

Edited 3 time(s). Last edit at 03/14/2018 01:16PM by MKSA.

---

"A comical prototype doesn't mean a dumb idea is possible" (Thunderf00t)