Hi folks!
I am relatively new to this firmware and I have Duet WiFi board with web client.
My company have recently produced a custom new thermistor for 3D printer. I have a PDF here and a task to make it properly work in the firmware, but I have no clue where to start. i went into config file, and found some values there, also looked through the wiki already. Does not help much in my situation.
The only value that I have in this document is: B(150/250)=5300K +/-3%
I also have a million of resistance values for this thermistor for million temperature points.
My second question is whether it is possible to control how much power is going into heater cartridge, and if yes, where to find that.
Would really appreciate if someone can shed some light for me.
