Welcome! Log In Create A New Profile

Advanced

New to Duet Wifi and RepRapFirmware

Posted by FA-MAS 
New to Duet Wifi and RepRapFirmware
November 06, 2017 12:00PM
Got my new Delta built with a Duet Wifi, currently running firmware 1.19. Never used either before, it's quite different than I what I know.

I'm running through the configurator (https://configurator.reprapfirmware.org/)
And have questions, on the first page.

Firmware Compatibility, what should I have this set to?
Reads like it will emulate a particular firmware so it sends responses that certain host software can recognize. I don't plan on using anything like Pronterface or Repetier.

Enable non-volatile memory, should I enable?
Re: New to Duet Wifi and RepRapFirmware
November 06, 2017 02:49PM
The firmware compatibility setting only affects communication over USB. The usual selection is Marlin because that's what Pronterface and similar programs assume.

Non-volatile memory: this is like EEPROM on 8-bit firmwares. Your choice.


Delta printer calibration calculator, mini IR Z probe, and colour touch screen control panel: [escher3d.com]

Large delta printer, and other 3D printer blog postings: [miscsolutions.wordpress.com]

Disclosure: I have a financial interest in sales of the Panel Due, Mini IR height sensor, and Duet WiFi/Duet Ethernet [www.duet3d.com].
Sorry, only registered users may post in this forum.

Click here to login