Hi,
I tried to test my new CNC mill Y-Axis motors.
In the left corner: NEMA23 with 2.1A 1.8°
In the right corner: NEMA17 with 2.4A 0.9°
I mapped the drivers like that: M584 X0 Y1:4 Z2 E3
and set the steps/mm like: M92
Y12800:6400
But both steppers run at the same steps/mm.
Q: Can I use
M350 X16 Y16:8 Z16 I1 instead?
I know, it isn't relevant in real life, but I wanted to test both steppers at once to figure out noise level, max. speed and torque.