Welcome! Log In Create A New Profile

Advanced

Connecting your Duet 0.85 Straight to Computers Ethernet

Posted by chris33 
Connecting your Duet 0.85 Straight to Computers Ethernet
June 07, 2017 08:04AM
Ok i thought i would post this here for relevance and searchable material as i struggled myself to understand what i needed to do to run the duet 0.85 from the computer alone without no bridge or needing a router or cross over cable as my delta i wanted it to be able to take it places where there might not be router, now this as i believe will only work if your adapter has autoconfiguration,

To check i opened command prompt and typed in ipconfig/all look for this

SJG3Kw3l.jpg

Then i went to my settings opened the Ethernet tab/change adapter settings
Then right clicked Ethernet in network card go to properties

HhXncqdl.jpg

I highlighted internet protocol version 4 (tcp/ip4) and select use te following as i set my duet ip address as 192.168.0.31 so i put in one few numbers below

P1AndE1l.jpg

Im glad i got it too work as webcontrol user interface is probably best interface ive used to control a printer

Edited 2 time(s). Last edit at 06/07/2017 11:13AM by chris33.

Check my rubbish blog for my prusa i3

up and running
[3dimetech.blogspot.co.uk]
Re: Connecting your Duet 0.85 Straight to Computers Ethernet
June 07, 2017 02:37PM
Thanks for posting that guide!


Delta printer calibration calculator, mini IR Z probe, and colour touch screen control panel: [escher3d.com]

Large delta printer, and other 3D printer blog postings: [miscsolutions.wordpress.com]

Full disclosure: I have a financial interest in sales of the Panel Due, Mini IR height sensor, and Duet WiFi/Duet Ethernet.
Sorry, only registered users may post in this forum.

Click here to login