Welcome! Log In Create A New Profile

M557 after M558?

joestefano

M557 after M558?
January 21, 2017 07:50PM

Registered: 11 years ago
Posts: 118

; Endstops
M574 X1 Y1 Z0 S0 ; Define active low and unused microswitches
M558 P1 X0 Y0 Z1 H5 F120 T6000 ; Set Z probe type to modulated, the axes for which it is used and the probe + travel speeds
G31 P500 X0 Y0 Z1 ; Set Z probe trigger value, offset and trigger height
M557 X0:270 Y0:270 S50

Does it matter?

Reply Quote

dc42

Re: M557 after M558?
January 22, 2017 04:23AM

Registered: 10 years ago
Posts: 14,672

The ordering restrictions on gcodes in config.g are described at [duet3d.com].

Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].