would it be possible to add easily a Z live button on web interface ?
On my Prusa I3 MK2, I can change the head heigh while printing the first layer. This should be the equivalent to change the Z sensor height parameter while printing.
I think it's very useful to have the possibility to adjust in live the head heigh at the first layer.
Yes, if I use Z +0.05 two times while printing, the head go up of 0.1mm but after next layer, the head heigh come back to origin, the offset I put before with Z +0.05 is canceled.
This functionality is very useful. I use it on my Prusa I3 while printing the skirts to adjust Z heigh on the first layer. and this parameter is keeped hile all printing
Interesting! Didn't think that through. Until DC drops the new version that has it, you could use gcode macros to do the same thing I believe. adjust your Z then click a macro that runs G92 Z(your first layer height). That'd work for the time being I think.
Edited 1 time(s). Last edit at 01/16/2017 06:58PM by clearlynotstefan.