So with the new G29 command, I've noticed a G32 wipes out the bed compensation from a G29. Based on the G-code list on the RepRapWiki, it says for a G32 it will execute the macro bed.g instead of using the M557 points. I've been using a bed.g file for quite a while now, but is it possible to change the contents of the bed.g file to just be G29 S1? Then I'll manually run a G29 when I either change the bed mounting or if something looks off at the start of a print.
I'm wondering about some of the older Gcode files I have sliced in the past that called G32 after a G28, but I'd rather not wipe out the G29 probing (primarily due to how long it takes to probe the bed). Could I change my bed.g to just call a G29 S1? Or would that cause issues with some of the DWC buttons or PanelDue buttons for bed compensation? I really don't want to purge all my old code files if I don't have to, or hand edit them if I don't need to.