stepper motor behavior April 20, 2016 12:33PM |
Registered: 8 years ago Posts: 5 |
Re: stepper motor behavior April 21, 2016 01:39PM |
Registered: 8 years ago Posts: 5 |
Re: stepper motor behavior April 21, 2016 06:36PM |
Registered: 10 years ago Posts: 14,672 |
Re: stepper motor behavior April 22, 2016 03:41AM |
Registered: 9 years ago Posts: 1,159 |
Quote
Pz212
this is the m666 and m665 comands in console right after the bed leveling. i trid updating to the latest dc42 firmware but still the same issues.
tried putting in new config files aswell but still the same issue
Re: stepper motor behavior April 22, 2016 07:34AM |
Registered: 8 years ago Posts: 475 |
Quote
dougal1957
Quote
Pz212
this is the m666 and m665 comands in console right after the bed leveling. i trid updating to the latest dc42 firmware but still the same issues.
tried putting in new config files aswell but still the same issue
First thing I noticed is that you have rod length at 310 and Bed Radius at 290.0 one of those must be wrong and I suspect you have put in the Bed Diameter rather than its radius?
I Think at those setting's it is probably confusing the hell out of the Cal routines but DC42 will have to comment on that as I am no expert.
HTH
Doug
Re: stepper motor behavior April 23, 2016 03:31AM |
Registered: 8 years ago Posts: 5 |