Hello and thanks in advance for any advice or help. In search of a quality RAMPS board ordered kits from RobotDyn in China, boards look great, Mega clone is great (though CH340G, no big deal), graphics controller is great, BUT... It has dual SD slots, one standard and one micro. It will not read SD cards with the standard SD card configuration enabled (have had no issues configuring RAMPS for typical full graphic controllers with single SD slot). I have 2 of these, neither work, and have tried multiple cables. I can simply buy the crappy ones to replace these, not much money, but these are much better quality workmanship, and I don't like waste, so I thought I would see if anyone had thoughts about how to make these work, or if anyone has had experience with controllers such as this. Thanks again.
Edit: Display works perfectly, so does rotary encoder, just SD that I can't configure.
Edited 1 time(s). Last edit at 05/02/2018 03:11PM by JamieTime.