Hello
I have a Anet A8 and I'm convert it to a AM8. So I tough, I change the Display too. I bought this [
ch.farnell.com]
It is a 20x4 OLED Display with a HDD44780 compatible controller. So far so good - I think
But I have some weird problem/behavior -> [
youtu.be]
And this is not the only one. The horizontal Lines are at the wrong position.
Is:
X 0 Y 0 Z 0
Temp.Nozzle 0/0 Heatbed 0/0
AM8 Printer ready
100% Time: 00:00
Should be:
Temp.Nozzle 0/0 Heatbed 0/0
X 0 Y 0 Z 0
100% Time: 00:00
AM8 Printer ready
The only thread I found about the OLED was: [
shop.prusa3d.com] (thanks to the thingiverse user 0scar)
Is that realy so, that we have to change the marlin code to run this freaking expensive display properly?
EDIT:
Display: [
ch.farnell.com]
Datasheet: [
www.farnell.com]
Edited 1 time(s). Last edit at 03/08/2018 06:29PM by Nitec0re.
