Hi all,
The project I am working on doesn't use hot extruders at all and I'd like to disable anything and everything related to heating and fans, especially the periodic M105 check which I think is somehow causing my "prints" to stop in the middle and lose track of everything. I have looked all over the code this morning and tried this and that and was hoping that I missed something and there's a nice, simple way to do this.
I have done the suggested things like increasing timeouts, buffers, etc. but my prints get lost in the middle of complex drawings and pick up later, usually the machine has also lost its positioning by then. I know this may have nothing to do with the M105's but I'd like to disable them anyway, and anything else related to heated extruders or beds. Hoping there's a flag somewhere I missed.
At a minimum, can someone point me to where in the code that periodic M105 is being generated from? Can't seem to find it. Or is it not coming from Marlin at all and I'm confused?
Thanks for any suggestions!
Edited 3 time(s). Last edit at 02/23/2018 12:41PM by Sundog.
