Hi,
I have a cartesian printer working fine with marlin 1.03 dev.
Home pos is on the hight right corner.
Bed is x245 X y210 X z200
homing values are :
x = 245
y = 210
z = 0
So, i flash with marlin 1.1.6.... and badaboum
homing values are :
x = 120 (245 / 2 ????? why lol)
y = 105 (210 / 2 ??)
z = 0 (yes, z is ok !!)
I don't understand why, but it seems my printer believe it is centered at the bed center!! there is a //bed_center_0_0 in the code, but it is not defined......
The homing goes home without problems, but values for x y aren't good, i must have x = 245 y = 210 after homing and with 1.1.6 it is x = 120, y = 105
Why, why, why, why, i am loosing my mind lol
Oh, the problem is the same on repetier software, or direct on lcd panel....
I used the same values and variables in 1.0.3 and in the 1.1.6... i have checked all the fracking code....
If i flash with the old 1.03 fw, all is good....
Thx for your help.
Riker