Hello Everybody,
I have a Problem with my Makibox(newer Model with a 5D Print D8 board): After having some Problems with the original Firmware on the Board, i decided to re-program it with Marlin.
After Configuring the Firmware to fit my printer and flashing the Board, i noticed that the limit switches weren't working:
When you try to home an Axis, it reaches the Limit switch without the motor shutting of.
I suspect, that the Problem has to do with the original Pin configuration, but i don't know how to figure out the correct Pins.
If somebody knows how to find out the Pins and where to change the Values or has a working Configuration, please post it.
PS: The switches still work in the original Firmware, so the Hardware is not at fault.