1.1.1 lost heated bed

I have installed 1.1.1 onto my Sanguinololu 1.3 and I have almost everything working well.

But I have lost my heated bed totally. It does not show up on the LCD or in any software.

I have checked all my wires and everything is connected as it was before, I did put the Sanguinololu into a case so I did have everything disconnected but I made certain everything is as it was.


Any ideas?

I have been thru the configuration.h over and over I just dont see whats missing.

Edited 1 time(s). Last edit at 05/26/2017 12:18AM by JustSumGuy.

found it, dang that 0 should have been a 1

#define TEMP_SENSOR_BED 0