Hi,
I'm updating RC8 to bugfix 1.1.0. I got a error while compiling that says:
SanityCheck.h:521: error: #error "Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN requires Z_MIN_ENDSTOP_INVERTING to match Z_MIN_PROBE_ENDSTOP_INVERTING."
#error "Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN requires Z_MIN_ENDSTOP_INVERTING to match Z_MIN_PROBE_ENDSTOP_INVERTING." //changed
Thing is if i set those parameters both to false, as the erros says the probe goes in the wrong direction while probing.
When I set
#define Z_MIN_ENDSTOP_INVERTING true
#define Z_MIN_PROBE_ENDSTOP_INVERTING false
as before in RC8 (without error) and comment the error section out in the sanitycheck.h file it works.
Is this a problem? Why should those parameters be the same?
Edited 1 time(s). Last edit at 05/21/2017 11:31AM by h4nc.