Using RC8 with AUTO_BED_LEVELING_BILINEAR enabled. Documentation says that you can override number of points to probe with G29 X Y, or G29 P. Neither command works for me. It still always probes the default number of points hardcoded in the software (in my case, 3x3). Any clues?
Also, in this version, is there a way to change an individual probed point's correction?
Is there a way to output the topology map without redoing the entire routine? (G29 T. This always reruns the entire probing routine for me).
Is there a way to just confirm that auto leveling is enabled? I don't see an option for that.
Cheers-
Scott