Hi,I have a Ramps 1.4 setup on a chinese Aurora I3 printer.
After fitting a bowden type extruder,tyring to update the settings I ran into the following problem.
When trying to upload the sketch to ramps,i get this error:
status1.
SERIAL_PROTOCOLLN(((READ(X_MIN_PIN)^X_MIN_ENDSTOP_INVERTING)?MSG_ENDSTOP_HIT:MSG_ENDSTOP_OPEN));
I think it was line 2797 in the main marlin file
The x-endstop on the printer is working fine.
Can anyone tell me what this means,and how i can correct it?
It appears that the board is not accepting the new settings,as when extruding 10mm,i get about 90mm of filament.
The previous extruder was a wade's geared job,so obviously,the board is still using that setting.
I will try to attach my marlin,configuration.h and pins.h files
I would be grateful for any help.Many thanks.clogs.
