Hi guys. I Built my first RepRap and this month I had my first sucess in print a solid.
But now I want to connect my printer by bluetooth. I configured my module alredy, but my doubt is: the module baud and printer baud must be the same for it to work?
In "Ramps 1.4" section in RepRap wiki haves a topic directed to bluetooth connection, but do not say anything about baud conciliation. In this topic, the wiki recommends to set the module baud at 115200, but in my configuration.h from Marlin Softwere, I set the printter baud to 250000. And the module do not support this baud. The closest baud there is 230400, but I tryed to put this number in Marlin softwere and the MatterControl was failed to conect the printer.
Should I ser my printter boud to 115200?
I am using a jy-mcu bluetooth module, just like said in that topic.
Edited 2 time(s). Last edit at 08/23/2016 06:29AM by BirdFireBR.
