Welcome! Log In Create A New Profile

Bed PID autotune not working

[email protected]

Bed PID autotune not working
June 02, 2016 08:07PM

Registered: 7 years ago
Posts: 10

I have been trying to get PID working on my hot bed but every time i run the m303 e-1, i get an error "PID Autotune failed! Bad extruder number"

#define PIDTEMPBED has been enabled I don't know what else I have to do to get it working.

Edit: I have rolled back my firmware to latest stable release and I can get it work. However it doesn't work on RC6

Edited 1 time(s). Last edit at 06/02/2016 09:14PM by zggtf211@gmail.com.

Reply Quote

[email protected]

Re: Bed PID autotune not working
June 02, 2016 09:32PM

Registered: 7 years ago
Posts: 10

Closed. Was editing the old Configuration.h. Had the old and RC6 open at the same time. spinning smiley sticking its tongue out