Welcome! Log In Create A New Profile

1.1.0-RC6 No LCD menu? (SOLVED)

Posted by Veesta

Veesta

1.1.0-RC6 No LCD menu? (SOLVED)
May 05, 2016 05:14AM

Registered: 8 years ago
Posts: 165

Hi there,

Just enabled

#define REPRAP_DISCOUNT_SMART_CONTROLLER
#define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER

And it brings stuff to display, but the rotary knob is dead and no beeps.
I cannot get to the LCD menu.

LCD menu/knob/beep works if i revert back to older version of Marlin, so the display/board is working.

Edited 2 time(s). Last edit at 05/05/2016 09:45AM by Veesta.

Reply Quote

Veesta

Re: 1.1.0-RC6 No LCD menu?
May 05, 2016 09:45AM

Registered: 8 years ago
Posts: 165

Aaand... Solved. grinning smiley

I'm running a "dry installation" on electronics that are not connected to anything. Just to toy with it.

I was having "ERR: MINTEMP" because i had no thermistor connected.

Add a thermistor -> Rock and roll again...

Reply Quote

stephenrc

Re: 1.1.0-RC6 No LCD menu? (SOLVED)
May 05, 2016 10:21AM

Registered: 12 years ago
Posts: 548

You only need to select one LCD define.

The first one is for a 20x4 LCD and the second one is for a graphic LCD.