"The printer also has an external part to boost the voltage." pictures might help... not sure what your talking about here.
"How difficult is this process?" easy... main issue is any incompatible plugs, so you have to change a few plugs over.
"Does ramps calibrate the motors" no. standard pololu stepper drivers all use the variable resistor to set the current. Or if your talking about steps/mm type stuff, thats firmware settings
"A separate problem is my heat bed has stopped working" 9/10 time this is a dead MOSFET on the controller...
Edited 1 time(s). Last edit at 01/27/2018 08:20PM by Dust.