A supplier for sourcing XTC-3D - A product for smoothing and finishing 3D printed parts.
XTC-3D doesn't melt plastics. Two liquids are mixed together and brushed onto 3D prints. Coating self levels and wets out uniformly without leaving brush strokes.
Working time is 10 minutes and cure time is about 4 hours (depending on mass and temperature).
XTC-3D cures to a hard, impact resistant coating that can be sanded, primed and painted.
Can be applied to both SLA and SLS prints. It works with PLA, ABS, Laywoo, Powder printed parts and other rigid media. It also can be used to coat EPS, EPDM and urethane foam as well as wood, plaster, fabric, cardboard and paper.
Coverage - A very small amount of XTC-3D is needed to coat an average size print. 1 oz /28.3 grams of mixed material will cover 101 square inches/651 square cm applied at 1/64" (0.4cm) thickness.