Hi Oatridge,
oatridge Wrote:
-------------------------------------------------------
The print starts then almost immediately
> the printer adds .19mm to the Z height.
When exactly does it add the extra? I'm sure you're aware that as soon as the Z axis homes, it will lift slightly again (according to the layer height set) just prior to the X,Y moving to the centre. In effect, it adds the layer height set in Slicr3 to the Z=0 (0.1mm?) height. At least, that's the way I see it!
So is it lifting again after it reaches the bed centre or something?
_______________________________________
Waitaki 3D Printer