Welcome! Log In Create A New Profile

Advanced

Odd problem! rotation??

Posted by jimmyjim 
Odd problem! rotation??
December 14, 2017 11:03PM
The little fisher has been doing well, most prints being successful.

I've started to have an odd problem. It prints the first layers ok, then probably every 2 or 3 layers its rotating around the centre line of the bed!

I'm using the same slicing software I've always used and not put on any updated software on the printer.

Can any one offer any ideas where the problem lies? A friend said it could be power to the motors????

thanks Jim
Re: Odd problem! rotation??
December 15, 2017 08:16AM
is the bed secure could it be rotating thru vibrations?

Doug
Re: Odd problem! rotation??
December 16, 2017 07:18PM
Thanks, I've not checked that!

I will check next time I run.

Thanks Jim
Sorry, only registered users may post in this forum.

Click here to login