Finished and working... November 07, 2016 10:53AM |
Registered: 7 years ago Posts: 16 |
Re: Finished and working... November 07, 2016 02:43PM |
Registered: 10 years ago Posts: 14,672 |
Re: Finished and working... November 08, 2016 02:38AM |
Registered: 8 years ago Posts: 301 |
Re: Finished and working... November 09, 2016 07:08AM |
Registered: 7 years ago Posts: 16 |
Re: Finished and working... November 09, 2016 02:06PM |
Registered: 10 years ago Posts: 14,672 |
Re: Finished and working... November 10, 2016 04:01PM |
Registered: 7 years ago Posts: 21 |
Re: Finished and working... November 10, 2016 04:52PM |
Registered: 10 years ago Posts: 14,672 |
Quote
Gary J
Hi dc42, i would like to make the changes in config.g as described but when I run the Auto Delta Calibration I just get a small blue strip across the bottom of the screen showing with what seems a variance measure 'Calibrated 4 factors using 4 points, deviation before 0.022 after 0.000'
Where do I find or how do I get the x,y,and z parameters to enter into the config.g.
Regards Gary J
Re: Finished and working... November 13, 2016 01:44PM |
Registered: 7 years ago Posts: 5 |
Re: Finished and working... November 14, 2016 05:59AM |
Registered: 7 years ago Posts: 16 |
Re: Finished and working... November 14, 2016 08:04AM |
Registered: 10 years ago Posts: 14,672 |
Quote
cparsons
More worryingly is that on several occasions the 'Home All' caused the print head to crash into the print bed (usually off centre) requiring an emergency stop and power off reset - at which point it behaved again .
Re: Finished and working... November 14, 2016 08:09AM |
Registered: 7 years ago Posts: 16 |
Re: Finished and working... November 14, 2016 12:01PM |
Registered: 7 years ago Posts: 21 |
Re: Finished and working... November 15, 2016 04:54AM |
Registered: 7 years ago Posts: 16 |