Welcome! Log In Create A New Profile

COOLING FANS

Posted by skaha

skaha

COOLING FANS
May 06, 2018 05:59PM

Registered: 6 years ago
Posts: 54

Hi I am on my second chinese clone, it is printing well, my question is does anyone use the ducted fan that is supposed to start up after the first layer is down ? Neither of these units work, I have checked they are plugged into proper terminal on the board. The extruder fan works fine. My newer printer is a JGAORORA.
Thanks for any suggestions offered.
Terry

Reply Quote

Roberts_Clif

Re: COOLING FANS
May 06, 2018 08:13PM

Registered: 6 years ago
Posts: 1,863

Quote
skaha
My question is does anyone use the ducted fan that is supposed to start up after the first layer is down ?
Terry

I have a 3DP11/3DP12 the duct fan works correctly, and can set exactly what layer for it to start and change the layer speed on any or all layers thereafter.

Quote
skaha
I have checked they are plugged into proper terminal on the board.
Terry

I would suggest to test the fans to see if they work at all.
I would check to see if the duct fans are wired correctly.

Edited 2 time(s). Last edit at 05/06/2018 08:15PM by Roberts_Clif.