Welcome! Log In Create A New Profile

Advanced

Help for Anet A8 with Megatronics V3.1

Posted by DirkC 
Help for Anet A8 with Megatronics V3.1
February 08, 2018 11:40PM
Because my controller of the ANET A8 printer was defect i have replaced it with the Megatronics V3.1.
Can somebody help me with the configuration because i can't get it working.
I've already uploaded Marlin firmware with some correction of the configuration.h file but it does nothing.
Do i have to use stepper drivers ? I had not with the previous board. Hope someone can help me Thx
Re: Help for Anet A8 with Megatronics V3.1
February 09, 2018 12:23AM
Yes you need stepper drivers
Sorry, only registered users may post in this forum.

Click here to login