As the tittle says, I have a CR-10 Mini, I just upgraded to the E3D v6 pt100 capable hot end, Have successfully upgraded my firmware to marlin 1.1.8, everything reads and works save for the pt100 thermister (it reads without the amp board just way off, the closet I was able to get it was -20 threw the options Marlin has), and thus the hot end wont heat or will error. I had read in a few places that it could be wired directly without the pt100 amplification board, this is not the case, What I need help with is editing pins.h for pin 29 on the s-Melzi board, it is the only spare input pin on the CR-10 Melzi boards, It is pin 29, Port A2, the pin is one of the unused pins from the display port socket, bottom left pin I do believe, It reads on the sheet as "unused/unknown" input. EDIT* After looking at [
github.com] it would appear it is LCD_PINS_D7
Edited 2 time(s). Last edit at 01/02/2018 10:37AM by R3dRumG33K.
