Welcome! Log In Create A New Profile

Y axis moves 4 times too far then X axis!!??

Posted by OlaA

OlaA

Y axis moves 4 times too far then X axis!!??
November 01, 2017 01:57PM

Registered: 7 years ago
Posts: 26

Hey!
I am a beginner of this. I have uploaded Marlin 1.1.6 to Geeetech 2560 rev. A in my Prusa i3 clone.
In Configuration h. I have 7 as motherboard.
Has set DEFAULT_AXIS_STEPS_PER_UNIT {78.74,78.74,2399,102.5} Everything works except that the Y axis moves 4 times too far.
The X-axis is perfect. As I see it, X have the same physical conditions as Y.
What do I miss?

Regard
Ola A.
Linköping
Sweden

Reply Quote

Dust

Re: Y axis moves 4 times too far then X axis!!??
November 01, 2017 04:43PM

Admin
Registered: 13 years ago
Posts: 7,000

One of your micro stepping jumpers (under the Y stepper driver) is missing or just not working.. Check all 3 jumpers exist and that there is a bit of metal in the jumper.

Reply Quote

OlaA

Re: Y axis moves 4 times too far then X axis!!??
November 02, 2017 01:08AM

Registered: 7 years ago
Posts: 26

Yes of course :-) I forgot them. I'm going to check them out, and hold my thumbs. Thanks. winking smiley

Reply Quote

OlaA

Re: Y axis moves 4 times too far then X axis!!??
November 02, 2017 08:07AM

Registered: 7 years ago
Posts: 26

Quote
Dust
One of your micro stepping jumpers (under the Y stepper driver) is missing or just not working.. Check all 3 jumpers exist and that there is a bit of metal in the jumper.

Finally. Now everything works as it should. Some of the jumpers probably had a bad connection. Thank you for your attention and commitment. thumbs up