For refresher [
reprap.org]
Otherwise it's what works best for you: time and budget.
I'm using; Repetier Host v1.6.2 with the Cura embedded slicer mostly. I use Win 8.1 and generate the Gcode on that computer.
Then I upload it to a RPI 3 over wifi (which I put a $5 PS3 camera on) and print from browser interface. {best $45 spent to date}
Firmware Marlin (I used Therippa's version [
github.com]).
With the Folgertech you have the advantage that since that is what it 'shipped' with, that is what a lot of people use and have contributed to.
Easier to not reinvent the wheel, imo.
But many people swear by other softwares, so idk? I personally like the ability to clone someone else's settings and get printing (making small tweaks).
I have not had the time or money to try these other people's suggestions.
Edited 1 time(s). Last edit at 06/06/2017 10:34PM by VonRansak.