Hello RepRappers,
I'm new to the maker scene and very excited to be here. I ordered a DIY Prusia i3 clone (Tronxy P802-MA v.07) and have had a fun time usiung it. I've installed a glass bed over the aluminum one, and my inductive sensor is now proving unreliable. I'm a little overwhelmed in the electronics area as a noobie. I'd like to buy this
PiBot optical sensor, but I just don't quite know how to determine whether its compatible without modification.
Some other related information on it:
[
www.pibot.com]
My board is a Melzi 2.0 1284P:
[
www.aliexpress.com]
Can this one just be immediately swapped out with my inductive sensor (after some firmware changes probably). I'd be grateful for any guidance.
Thanks,
Edited 1 time(s). Last edit at 05/14/2017 07:49AM by Right.