Im fairly new my self.(to. 3d printing) Have been thinking for a few moth. Its really interning in many aspects.
Im sure you will have fun.
I distance between bed. is about 0.1mm.
Use a normal A4 paper as a "shim" between the bed and the nozzle. You should feel the nozzle "scratching" the nozzle when moving it
around between nozzle and bed.
I print PLA with about 205C. bed at about 50C. Fan off for the 2 first layers. then it goes to full.
ABS about 250C. bed 70C. No fan..
Hope it helps.
You will have to adjust (probably) to you're printer though.
first. start with 30mm print speed. then try higher setting later..