Start g-code setting for correct nozzle position March 17, 2017 06:47PM |
Registered: 7 years ago Posts: 94 |
Re: Start g-code setting for correct nozzle position March 18, 2017 03:09AM |
Admin Registered: 13 years ago Posts: 6,995 |
Re: Start g-code setting for correct nozzle position March 18, 2017 10:28AM |
Registered: 7 years ago Posts: 94 |
Re: Start g-code setting for correct nozzle position March 18, 2017 10:43AM |
Registered: 7 years ago Posts: 759 |
Re: Start g-code setting for correct nozzle position March 18, 2017 01:38PM |
Registered: 7 years ago Posts: 94 |
Quote
obewan
In configuration.h you can set the X and Y offset after homing
Quote
// Travel limits after homing
#define X_MAX_POS 220
#define X_MIN_POS -33
#define Y_MAX_POS 220
#define Y_MIN_POS -10
#define Z_MAX_POS 230
#define Z_MIN_POS 0
Re: Start g-code setting for correct nozzle position March 18, 2017 06:45PM |
Registered: 7 years ago Posts: 759 |
Quote
SatorCodex
Quote
obewan
In configuration.h you can set the X and Y offset after homing
Quote
// Travel limits after homing
#define X_MAX_POS 220
#define X_MIN_POS -33
#define Y_MAX_POS 220
#define Y_MIN_POS -10
#define Z_MAX_POS 230
#define Z_MIN_POS 0
I have tried to change those parameters. But, I get compiling error. due to the (fact?) that its out of the boundaries for the inductive sensor.
Im trying to learn.. I'm trying to.. But its going slowly..
Re: Start g-code setting for correct nozzle position March 19, 2017 12:37PM |
Registered: 7 years ago Posts: 94 |