board I used to have was over the 200x200.. it was not heating correct.. so had to replace with standard 200x200
but now when I it Y home it goes off the bed.. Marlin is set like this
#define X_MAX_POS 180
#define X_MIN_POS 0
#define Y_MAX_POS 200
#define Y_MIN_POS 0
#define Z_MAX_POS 185
#define Z_MIN_POS 0
I tried to make Y max smaller didnt help.. and I Assume that is because that is not going to affect
my Zero...
how can I move my Y home to be at the edge of the head bed ? I assume I could make my Y_MIN be 20 or something
but that seems wrong...
