Welcome! Log In Create A New Profile

Reprap Prusa i3 Rework Ready Marlin Firmware

Golemanov

Reprap Prusa i3 Rework Ready Marlin Firmware
March 05, 2017 10:52AM

Registered: 7 years ago
Posts: 2

Hello Reprap fans.
Before a week ago I built my Reprap Rework. But for this week I cant deal with the Arduino code ... Can somebody give me the ready Marlin collection? The Configuration.h is the hardest thing.

Reply Quote

SteveRoy

Re: Reprap Prusa i3 Rework Ready Marlin Firmware
March 06, 2017 10:35PM

Registered: 10 years ago
Posts: 477

If it's a scratch build then you need to figure out most of the values yourself.
Depends on pulley size, belt type, z-axis threaded rods, extruder type etc etc

These are my notes from a recent build:
[www.instructables.com]

Steve

Reply Quote

Golemanov

Re: Reprap Prusa i3 Rework Ready Marlin Firmware
March 14, 2017 06:24AM

Registered: 7 years ago
Posts: 2

Quote
SteveRoy
If it's a scratch build then you need to figure out most of the values yourself.
Depends on pulley size, belt type, z-axis threaded rods, extruder type etc etc

These are my notes from a recent build:
[www.instructables.com]

Steve

Hello, Steve
I`ve done everything same as described in the link, but again nothing! When I upload on the Arduino the code and try to move for example 10mm from the pronterface X-axis ... nothing moves sad smiley

Before a couple of days I upload one Marlin Ready code. With this build the motors worked but they didnt syncronized well so my motors are working and well connected. Any other suggestions? Thank you very much!