E3D K type Thermocouple
Posted by veaceonee
|
E3D K type Thermocouple March 03, 2017 10:06AM |
So my Migbot I3 had a massive failure of a print. Wife woke up to a big smoldering plastic mass being pushed around the print bed. Anyway, I am using it as an excuse to upgrade from a Lite6 to a v6 hotend 
. I want to do the thermocouple upgrade ( Uses this adapter board ) so I can start printing with more than just the basics, but don't know how to hook up/configure the adapter board to the MKS Base v1.3 board. All online references are for RAMPS and Megatronics. I want to get all my ducks in a row before I order it. Any help would be appreciated. thanx in advance.
Edited 1 time(s). Last edit at 03/03/2017 10:07AM by veaceonee.
. I want to do the thermocouple upgrade ( Uses this adapter board ) so I can start printing with more than just the basics, but don't know how to hook up/configure the adapter board to the MKS Base v1.3 board. All online references are for RAMPS and Megatronics. I want to get all my ducks in a row before I order it. Any help would be appreciated. thanx in advance.Edited 1 time(s). Last edit at 03/03/2017 10:07AM by veaceonee.
Sorry, only registered users may post in this forum.