Hi all,
As a newbie in the world of 3D have to learn a lot. Did build my Tarantula kit with a poor manual and some internet movies.
But ..... It worked for me. Can move the x,y,z axes , the extruder runs, all with Repetier software on Win10.
But..... Can not heat up the bed and heatpipe. Repetier sounds an alarm when i push the print button.
Display on Tarantula says : pipe(symbol) def / 200 deg *B def / 80 deg.
The temp is set to: filament 200deg and bed 80 deg. On Repetier i can control the fan speed and move the axes, temp stays low even i set it high.
What goes wrong ??? Wiring is checked twice and according scematics.
Who is knowing the answer on the DEF note ??? What does this mean???
Regards
Kees
The Netherlands
