How cold was it today? The raft disconnected from the bed (covered by masking tape).
Had the brilliant idea to glue the raft back to the bed (fairly simple with some CA).
That was the easy part.
The harder part turned out to continue printing.
Made a few attempts to manipulate the G-code, but was unsuccessful.
Finally just re-sliced it in Cura with 1st layer height at 1.2mm.
Print started correctly, but after 2-3 layers it stops and returned to idle.
Examined the file (from the sd-card) and after the 3rd layer it's only gibberish (see attached photo).
Re-sliced it (to get a correct file) and turned on "Dry-Run" - stopped at the same point at the 3rd layer.
What is going on?
